Filter
Top Products
_1productor con
)o por remolcar
Dtras personas
molcar.
uipo remolcado
ci6n y la p6rdida
tnciaparafrenar.
LA GASOLINA
o daSos alas
la hora de ma-
extremamente
Iosivos.
igarros, pipes y
olinaaprobados.
line o aSadir car-
i. dejar enfriar el
de la gasolina.
terior deun local.
el contenedor
a llama abierta,
in calentador de
,s a! interior de
,ana o cami6n
I_.stico. Colocar
el terreno lejos
_nando,
ni6n o caravana
i no es posible,
un contenedor
Jrtidor de gaso-
acto del borde
la abertura del
operaci6n de
dispositivo con
ropa, cambiarse
de Io debido.
gas y cerrar de
GENERALES
ulna en un &rea
_rnos apretados
ten condiciones
_sde seguridad.
_miento regular-
TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
CAUSE
Weak or dead battery.
Corroded battery terminals.
Loose or damaged wiring.
Faulty solenoid or starter.
,L ,, ,,,,,,,,,,,,,,.,,,,,,,,,, ....................
1 Cutting too much grass/too fast.
2 Throttle in "CHOKE" position.
3 Build-up of grass, leaves and
trash under mower.
4 Dirty air filter.
5 Low oil level/dirty oil.
6 Faulty spark plug.
7 Dirty fuel filter.
8 Stale or dirty fuel.
9 Water in fuel,
PROBLEM
Engine clicks but
will not start
Loss of power
1
2
3
4
10 Spark plug wire loose.
11 Dirty engine air screen/fins. 11
12 Dirtylclogged muffler, 12
13 Loose or damaged wiring. 13
!4 Carburetor out of adjustment. 14
15 Engine valves out of adjustment. 15
Excessive vibration 1 Worn, bent or loose blade. 1
2 Bent blade mandrel. 2
CORRECTION
1 Recharge or replace battery.
2 Clean battery terminals,
3 Check allwiring.
4 Check/replace solenoid or starter.
1 Raise cutting height/reduce
speed.
2 Adjust throttle control,
3 Clean underside of mower
housing.
4 Clean/replace air filter.
5 Check oillevetfchange oil.
6 Clean and regap or change spark
plug,
7 Replace fuel filter,
8 Empty fuel tank and refill tank wilh
fresh, clean gasoline.
9 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
10 Connect and tighten spark plug
wire,
Clean engine air screen/fins.
Cleanlreplace muffler,
Check all wiring,
See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
Engine continues to
run when operator
leaves seat with
attachment clutch
engaged
Replace blade, Tighten blade bolt
Contact a Sears or other
qualified service center.
3 Looseldamaged part(s). 3 Tighten loose part(s).
Replace damaged parts.
1 Faulty operator-safety presence 1 Check wiring, switches and
control system, connections. If not corrected,
contact a Sears or other
29