Filter
Top Products
_I6N
_Utractor nuevo,
rendirn[ento y la
_cto de calidad.
continuacion:
is instrucciones
en Ia caja de
_rgada en forma
i forma c6moda
fladas en ferma
iv[o, las Ilantas
F_.brica.)
) segador est6
de tado a lado y
_araobtener los
rte. (Las llantas
orrna adecuada
3ulsi6n y de la
_corran el paso
3oleas y dentro
correas.
; que todas las
guras y que los
_rmaadecuada.
asegQrese que
; en la posicl6n
a" (Yea "PARA
',i6n de la Oper-
como usar su
los puntos de
continuacion:
e tlegar al nivel
tiene que estar
regular, nueva
controles - su
#elos antes de
; frenos estL_en
_egura.
_ade Presencia
Funcionamiento
nodo adecuado
lcienamiento y
lal).
nsmisi6n antes
mera vez. Siga
para el empiezo
EMPESAR EL
,R LA TRANS-
Operaci6n de
TO CHECK BRAKE
tf tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete or paved surface, then
brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or
paved surface, depress brake pedal
all the way down and engage parking
brake.
2. Disengage transmission by placing
freewheel control in "transmission dis-
engaged" position. Pull freewheel con-
trol out and into the slot and release so
it is held in the disengaged position.
The rear wheels must lock and skid
when you try to manually push the tractor
forward. If the rear wheels rotate, then the
brake needs to be serviced. Contact a
Sears or other qualified service center.
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal.
The front wheel toe-in and camber are
not adjustable. If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not lose).
3. Repair tire and reassemble.
NOTE: On rearwheels only: align grooves in
rear wheel hub and axle. Insert square key.
4. Replacewashers and snap retaining ring
securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use ti re sealant from Sears. Tire sealant also
prevents tire dry rot and corrosion.
Washers
Retaining
Ring
TO START ENGINE WiTH A WEAK BAT-
TERY
_WARNING: Lead-acid batteries generate
explosive gases. Keep sparks, flame and
smoking materials away from batteries.
Always wear eye protection when around
batteries.
If your battery istoo weak to start the engine, it
should be recharged. (See "BATTERY" inthe
MAINTENANCE section of this manual).
if "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: Your tractor is equipped with
a 12 volt system. The other vehicle must also
be a 12 volt system. Do not use your tractor
battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1. Connect one end ofthe RED cable to the
POSITIVE (+) terminalof each battery(A-
B), taking care not to short against tractor
chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of fully
charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground, away
from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER
1. BLACK cable first from chassis and then
from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead Fully Charged
Battery Battery
Axle Cover
I
,,Square Key (Rear
Wheel Only)
25