Filter
Top Products
AFTER EACH USE
Water should not remain inthe unit for long periods oftime.
Sediments of mineralscan deposit on pump parts and
"freeze" pump action. Follow these procedures after every
Use:
• Flush detergent hose by placing the injector filter into
a pail of clear water while running Pressure Washer
with nozzle in low pressure mode. Flush until you can
see clear water running through the tube.
• Shut off the engine and let it cool, then remove all
hoses.
A
CAUTION: Be sure throttle lever is in
"STOP" position before you continue. If
you start engine without the proper water
supply connected, you can damage the
pump.
Empty the pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most of the
liquid in the pump.
Coil the high pressure hose and inspect it for damage.
Cuts in the hose or fraying of it could result in leaks
and loss of pressure. Should any damage be found,
replace the hose. DO NOT attempt to repair a dam-
aged hose. Replace the hose with the genuine
Craftsman part.
Drain water from hose and properly hang it on the
wire support provided on the guide handle.
Note: To protect the unit from freezing temperatures, you
can draw windshieldwasher fluidintothe pumpby pour-
ingthe washer fluid into a 3-foot sectionof garden hose
connected to the inlet adaptor and pullingthe recoilhan-
dle twice.
• Store in a clean, dry area.
A
WARNING: NEVER store engine with fuel
in tank indoors or in enclosed, poorly venti-
lated areas where fumes may reach an
open flame, spark or pilot light as on a fur-
nace, water heater, clothes dryer or other
gas appliance.
LONG TERM STORAGE
If youdo notplantouse the PressureWasher for morethan
30 days,you mustpreparethe engineforlongtermstorage.
Note: As always, prepare the pressure washer pump as
you would after each use.
It is important to prevent gum depositsfrom forming In
essential fuel system parts such as the carburetor, fuel fil-
ter, fuel hose or tank during storage. Also, experience
indicates that alcohol-blended fuels (called gasohol,
ethanol or methanol) can attract moisture which leads to
separation and formation of acids during storage. Acidic
gas can damage the fuel system of an engine while in
storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. Follow these
instructions:
PROTECT FUEL SYSTEM
• Remove all gasoline fromthe fuel tank to prevent gum
deposits from forming on these parts and causing pos-
sible malfunction of engine.
_1_ WARNING: Drain fuel into approved con-
tainer outdoors, away from open flame. Be
sure engine is cool. Do not smoke.
• Run engine until engine stops from lack of fuel. Make
sure you have water supply to pump inlet connected
and turned ON.
CHANGE OIL
While engine is still warm, drain oil from crankcase. Refill
with recommended grade.
OIL CYLINDER BORE
• Remove spark plug and pour about 1/2 ounce (15ml)
of engine oil into the cylinder. Cover spark plug hole
with rag. Crank slowly to distribute oil.
I A CAUTION! Avoid spray from spark plug J
hole when cranking engine slowly.
I
• Install spark plug. Do not connect spark plug wire.
OTHER
Do notstore gasoline from one season to another.
Replace your gasoline can if your can starts to rust.
Rust and/or dirt in your gasoline will cause problems.
If possible, store your unit indoors and cover it to give
protection from dust and dirt. BE SURE TO EMPTY
THE FUEL TANK.
• Cover your unitwith a suitable protective._overthat
does not retain moisture.
IMPORTANT: NEVER cover your pressure washer while
engine and exhaust area are warm.