Filter
Top Products
CARTON CONTENTS
The following parts are shipped loosewith your pressure
washer:
• Main Unit -- pressurewasher with wheels and guide
handle
• Product IntroductionVideo
• Nozzle Cleaner Kit
• High Pressure Hose
• Parts Box (whichincludes itemslisted below
• Spray Gun
• Wand Extensionwith Hi-Lo AdjustableNozzle
• Wire Form
• Motor Oil
Become familiar with each piece before assemblingthe
pressurewasher. Check all contents againstthe illustra-
tion on Page 6. Ifany parts are missingor damaged, call
the PressureWasher Helplineat 1-800-222-3136.
TOOLS REQUIRED FOR ASSEMBLY
2 adjustable wrenchesOR the following wrenches
• 11/16" (17mm) wrench
• 7/8" (23mm) wrench
TO REMOVE PRESSURE WASHER FROM
CARTON
Remove loose parts and parts box includedwith pres-
sure washer. The high pressure hose is packed in the
bottom of the carton on the guide handle end.
Remove the hose.
• Slice two corners at guide handle end of carton from
top to bottom so the panel can be folded down flat,
then remove all packing material.
• Raise guide handle and secure in place.
Loosen knobs to
raise handle
,/
• Remove the unit by rolling it out the opening in the
carton, then check carton for additionallooseparts.
HOW TO SET UP YOUR PRESSURE WASHER
For the most part, your Craftsman High Pressure Washer
has been assembled at the factory. You must, however,
attach the wire form, assemble the spray gun, and attach
the high pressure hose to the pump and spray gun.
Note: Included with your unit is a video cassette that
demonstrateshow to set up your pressure washer. If
you have a viedo cassette recorder you may wish to view
the video beforeassemblingyour unit.
• Insertthe wire support withthe longer arm positioned
on the left. From this view the hookshouldresemble
a "J".
LONG
ARM
SHORT
ARM
Cut lie wrapon chemical injectiontube. Remove chemi-
calinjectionfilter, threadchemicaltube through the wire
form and reinsert filter into tube.
Tighten knobs
when handle
straight.