Filter
Top Products
RINSING WiTH THE PRESSURE WASHER
WARNING Be extremely careful if you must
use the pressure washer from ladder, scaf-
folding or any other relatively unstable loca-
tion. Pressure in a running washer builds in
the wand as you climb. When you press the
trigger, the recoil from the initial spray could
force you to fail, or if you are too close to the
cleaning surface, high pressure could force
you off a climbing apparatus.
• Hook up the water supplyand start your pressure
washer (see TO START THE PRESSURE WASHER).
• Slide adjustable nozzle back to high pressure position
and wait for detergent to clear. Detergent will not flow
when in the high pressure mode.
= When detergent has cleared you may want to expand
the spray pattern for a more gentle rinsing action.
Start at top of area to be rinsed, working down with
same action as for cleaning.
You can also stop detergent from flowing by simply
removing_phon from bottle.
HOW TO USE ADJUST PRESSURE USING
THE PRESSURE CONTROL KNOB
Located on the pump is a pressure controlknob. You can
increase and decrease the pressure of the spray by turn-
ing the knob clockwiseor counterclockwiserespectively.
_,The knob is set at maximum pressure at the factory.
HOW TO USE THE TURBO NOZZLE.
The turbo nozzle rotates the high pressure stream in a
rapid circularpattern. This increases the cleaning effec-
tiveness of the high pressure spray, Attach the turbo noz-
zle on the end of the nozzle extension.
The high pressure spray is most effective when the tip of
the wand is held between 8 to24 inches from the surface
being cleaned.
Important: The turbo nozzle produces an extremely high
pressure spray which is capable of removing paint and
cuffing holes through surfaces if held too close.Always
make sure the surface you will clean will not be damaged
by the high pressure spray.
HOW TO USE THE ROTATING BRUSH
Your pressure washer comes equipped with a rotating
brush. Use the brush to clean especially dirty surfaces, it
is a soft bristle brush with feathered ends that will not
scratch surfaces.
To connect the rotating brush to the spray gun:
o
o
Attach the accessory adapter to the rotatingbrush.
After attachingthe accessories adapter onto the rotat-
ing brush, attach the accessory adapter to the nozzle
extension.
- After attaching the accessories adapter onto the noz-
zle extension, attach nozzle extension onto spay gun.
Note: The rotating brush operates in low pressure
setting allowing you to dispense chemical with the
brush.