Filter
Top Products
CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CAN-
NOT CONTACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP,
TRANSPORTING, ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER.
_ AUTION: Before using this product,
read this manual and follow all Safety
Rules and Operating instructions.
o Engineexhaust gases contain DEADLY carbon monoxide
gas. This dangerous gas, if breathed in sufficient concen-
trations, can cause unconsciousness or even death.
Operate this equipment only in the open air where ade-
quate ventilation is available.
o Gasoline ishighly FLAMMABLE and itsvapors are
EXPLOSIVE. Do not permit smoking, open flames, sparks
or heat in the vicinity while handling gasoline. Avoid
spilling gasoline on a hot engine. Allow unit to coot for 2
minutes before refueling. Comply with all laws regulating
storage and handling of gasoline.
o Locate this pressure washer in areas away from com-
bustible materials, combustible fumes or dust.
The high pressure equipment is designed to be used with
Sears authorized parts only. if you use this equipment with
parts that do notcomply with minimum specifications, the
user assumes all risks and liabilities.
° Some chemicals or detergents may be harmful if inhaled
or ingested,causing severe nausea, fainting or poisoning.
The harmful elements may cause property damage or
severe injury.
Do not allow CHILDREN to operate the Pressure Washer
at any time.
o Operate engine only at governed speed. Running the
engineat excessive speeds increasesthe hazard of per-
sonal injury.Do net tamper with parts which may increase
or decrease the governed speed.
o Do not wear loose clothing, jewelryor anything that may
be caught in the starter or other rotating parts.
o Before starting the Pressure Washer in cold weather,
check all parts of the equipmentand be sure ice has not
formed there.
o Units with broken or missing parts, or without protecWe
housing or covers should NEVER be operated.
• The muffler and air cleaner must be installed and in good
condition before operating the Pressure Washer. These
components act as spark arrestors ifthe engine backfires.
o Check thefuel system for leaks or signs of deterioration
such as chafed or spongy hose, loose or missing clamps
ordamaged tank or cap. Correct all defects before operat-
ingthe PressureWasher.
o Do not spray flammable liquids.
o Never allow any part of the body to comein contactwith
the fluid stream. DO NOT come in contact with a fluid
stream created by a leak in the high pressurehose.
o High pressurestreams of fluid thisequipment produces
can pierce skin and its underlyingtissues, leading to seri-
ous injury and possible amputation.
o Never aim tile gun at people, animals or plants.
- High pressurespray can cause paint chips or other pa_-
cies to become airborne and fly at high speeds.
o Nways wear eyeprotectionwhen you usethis equipmentor
when you are in the vicinitywherethe equipmentis in use.
, Operate the pressure at no more than the PSI fluid pres-
sure rated for your pressurewasher.
o Never move the machine by pulling on the high pressure
hose. Use the handle provided on the top of the unit.
o Always be certain the spray gun, nozzles and accessories
are correctly attached.
• Never use a spraygun which does not have a tri_lgerlock
or trigger guard inplace and in working order.
• Use a respirator or mask whenever there is a chance that
vapors may be inhaled. Read all instructionswith the mask
so you are certain the mask will provide the necessary
protection against inhalingharmful vapors.
= High pressurespray may damage fragile items including
glass. Do not point spray gun at glass when inthe jet
spray mode.
• Keep Me hose connected to machine or the spray gun
while the system is pressurized. Disconnecting the hose
while the unit is pressurized is dangerous.
o Hold the spray gun firmly in your hand before you start the
unit. Failure to do so could result in an injuryfrom a whip-
ping spray gun. Do not leave the spray gun unattended
while the machine is running.
• The cleaning area should have adequate slopes and
drainage to reduce the possibilityofa fall due to slippery
surfaces.
= Keep water spray away from electric wiring or fatal electric
shock may result.
• Do not adjust unloader valve to a pressure in excess of
machine rating.
• Do not secure trigger gun in the pull-back (open) position.
= Do not by-pass any safety device on this machine.
o The muffler and engine heat up during operation and
remainhot immediately after shutting it down. Avoid con-
tact with a hot muffler or engine or you could be severely
bumed.
MAINTENANCE AND STORAGE:
* Operate and storethis unit on a stable surface.
, High pressure hose can develop leaks from wear, kinking,
abuse, etc. Water spraying from a leak is capable of inject-
ing material into skin. Inspect hose each time before using
it. Check all hoses for cuts, leaks, abrasions or bulging of
cover, or damage or movement of couplings. If any of
these conditions exist, replacehose immediately.Never
repair high pressure hose. Replace it with another hose
that meets minimum pressure rating of your pressure
washer.
LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. I
IT MEANS "ATTENTION!I! BECOME ALERT!H YOUR SAFETY iS INVOLVED."
I