Filter
Top Products
Position shifter lever assembly as shown
in figure below.
,€
Control Panel
• Reinstall bolt, spring, washer and Iocknut.
See last figure on page 7,
• Tighten Iocknut until 1/8 to 3/16 inch of
the bolt threads protrude past the Iocknut
• Thread the 3/8-16" hex jam nut onto the
lever until the nut roaches the end of the
thread. See last figure on page 7.
• Thread the plastic knob as far as possible
and ensure that the knob points forward.
• Tighten the 3/8-16" hex jam nut against
the knob securely.
• Move shifter through all speeds to ensure
proper tension of the spring. If shifter
lever sticks in any of the notches, loosen
Iocknut 1/2 turn at a time until shifter lever
moves more freely.
REMOTE CHUTE CONTROL KNOB
• Thread the 3/8-16" hex jam nut onto the
lever until the nut roaches the end of the
thread, See figure below.
• Thread the plastic knob as far as possible
and ensure tha the knob points forward.
• Tighten the 3/8-16" hex jam nut against
the knob securoly.
RemoteChute
Knob
3/8-16
HEADLIGHT
The headlight on your snowthrower is posi-
tioned in down position for packaging
purposes. Rotate upwards for operating po-
sition.
CHECKLIST
Before you operate your new snow thrower,
to ensure that you receive the best peffor-
mance and satisfaction from this quality
product, please review the following
check|ist:
-J All assembly instructions have been
completed.
_/ The discharge chute rotates freely.
q" No remaining loose partsin carton.
While learning how to use your snow
thrower, pay extra attention to the following
important items:
_/_ Engine oil is at proper level.
_/4 Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
4_/ Become familiar with all controls-their
location and function. Operate controls
before starting engine.