Filter
Top Products
• Remove top two bolts that secure auger
housing to motor mount frame. Loosen
bottom two botts, Auger housing and
motor mount frame willseparate, hinged
by bottom two bolts.
• Remove old bell from auger drive pulley.
• Install the original equipment replacement
belt in reverse order of removal.
• Position drive belt onto the auger ddve
pulley.
• Adjust the belt guide (see To Adjust The
Belt Guide paragraph).
• Reinstall the belt cover.
NOTE: You may have to move the auger
idler pulley more than once to obtain the cor-
rect tension.
• Check the clutch control cable adjustment.
• Reconnect the spark plug wire.
TRACTION DRIVE BELT
If your snow thrower will not move forward,
check the traction ddve belt (see second
figure on page 19) for wear (Check other
causes also in the Trouble Shooting Points
section). Ifthe traction drive belt needs to be
replaced, proceed as follows:
• Disconnect the spark plug wire.
• Remove the belt cover (see second fig-
ura).
• Loosen the belt guide and pull away from
auger drive pulley (see second figure on
page 19).
• Remove auger drive belt from auger pul-
ley (see second figure on page 19).
• Pull the traction ddve belt idler pulley
away from the traction drive belt (see
second figure on page 19).
• Remove the traction ddve belt.
• Position new traction ddve belt onto trac-
tion pulley.
• Pull idler pulley away from belt, allowing
beltto be positioned onto auger pulley.
• Check clutch control cable adjustment,
see page
• Reconnect the spark plug wire.
TO ADJUSTTHE BELT GUIDE
• Disconnect the spark plug wire.
• Remove the belt cover (see third figure
on page 19).
• Engage the auger drive clutch lever.
• Measure the distance between the belt
guide and the belt (see figure below). The
distance should be 1/8".
• If adjustment is necessary, loosen the
belt guide mounting bolt. Move the belt
guide to the correct position and tighten
the mounting bolt.
• Reinstall the belt cover.
• Reconnect the spark plug wire.
.("_X_ DrivePulley
AugerIdler--_
_ Impeller
TO ADJUST THE FRICTION WHEEL
If the snow thrower will not move forward,
you need to check the traction drive belt, the
traction ddve cable or the friction wheel, if
the friction wheel is damaged, it will need to
be replaced (see the To Replace Friction
Wheel paragraph on page 21). If the friction
wheel is not worn, check the adjustment, as
follows:
• Disconnect the spark plug wire.
• Drain the gasoline from the gas tank.
• Stand snow thrower on the auger housing
end.
• Remove the bottom panel (see figure be-
low).
Remove Bolts
Remove
To0
(Each "_'_"
Side) Looser_
' (each side)
_Bo_om Pane
bottombol_
(Bo_om View)
• Position the shifter lever in first (1) for-
ward gear.
• Note the position of the friction wheel on
the disc drive plate.Proper position from
the right outer side of disc drive plate to
the center of friction wheel should be 3"
(76 mm) (see next figure).
20