Filter
Top Products
FOR 1990 AND NEWER MURRAY FOR 1990 AND NEWER MURRAY
TRACTORS WiTH A 38" OR 40" DECK TRACTORS WiTH A 46" DECK
,
,
Cut out two templates and place on deck adapter as
shown in figure 29. Tape smaller one on top and larger
one on the side and bottom. After they are in place,
carefully mark around the templates, then cut out
adapter to obtain correct opening.
Bolt end of mounting strap to the 5/16" bolt on the
mower deck. The other end of the strap will bolt to
a hole in the deck adapter, which must be drilled.
Position the adapter on the deck, then drill a 5/16"
hole in the bottom of the adapter that will align with
the hole in the strap. Fasten the adapter to the strap
using a 1/4" x 3/4" hex bolt, 1/4" flat washer, nylon
washer and 1/4" nylock nut. See figure 29.
Assemble end of hose and hose clamp over the round
opening of deck adapter and tighten clamp.
,
,
Tape 46" template onto deck adapter. Mark and then
cut out adapter.
Fasten the angle bracket and the mounting bracket to
the mower deck as shown in figure 30. Use two 5/16"
x 3/4" carriage bolts, 5/16" flat washers and 5/16" lock
nuts. The bolt heads go on inside of mower deck.
3. Drill two 5/16" diameter holes in the deck adapter
that will align with the holes in the angle bracket and
the mounting bracket. Assemble the deck adapter to
both brackets using two 1/4" x 3/4" hex bolts, 1/4" flat
washers, nylon washers and 1/4" nylock nuts. See
figure 30.
4. Assemble end of hose and hose clamp over the round
opening of deck adapter and tighten clamp.
38"/40" TEMPLATE
TEMPLATE TO CUT OUT SLOT
CUT OUT SLOT IN TOP
OF DECK ADAPTER
1/4" × 3/4" HEX BOLT
1/4" FLAT WASHER
BOLT THIS END OF
STRAP TO 5/16" BOLT
ON MOWER DECK
NYLON WASHER
X,,MOUNTING STRAP
1/4"NYLOCK NUT
FIGURE 29
GO DIRECTLY TO THE OPERATION iNSTRUCTiONS
WHICH ARE LOCATED ON PAGE 18.
ANGLE BRACKET 1/4"NYLOCKNUT
_ MOUNTING
NYLON WASHER
X
1/4"FLAT
WASHER
FIGURE 30
GO DIRECTLY TO THE OPERATION iNSTRUCTiONS
WHICH ARE LOCATED ON PAGE 18.
16