Filter
Top Products
,
Position the adapter over the deck opening, and check
for fit of cutout as shown in figure 25. Trim cutout, if
necessary, to allow tilting of adapter, keeping the fit as
close as possible for best vacuum suction.
NOTE: Make sure adapter clears gauge
wheels on mower deck
DECK ADAPTER
,/
I
MOWER DECK
Curl on deck may be located outside of
adapter or inside depending on deck
opening design
FIGURE 25
6. Assemble the adapter bracket to the deck using two
5/16" x 1" hex bolts, 5/16" flat washers and 5/16"
nylock nuts. See figure 27.
NOTE: It may be necessary to use extra 5/16" flat
washers to shim under the bracket next to the deck
surface. Ten extra washers have been furnished as
shims. See figure 27.
'j(
2) 5/16" NYLOCK NUTS
®,
_-- (2) 5/16" FLAT
WASHERS
ADAPTER BRACKET
5/16" x 1" HEX BOLT/_
5/16" flat washers
used as needed for
shims to adjust for
variations in decks.
FIGURE 27
5,
Holding the adapter bracket and the deck adapter
together, position the deck adapter on the mower
deck. Keeping the edge of deck adapter as close as
possible to the offset in the adapter bracket, see if the
slot in the adapter bracket can be aligned with one
or two of the deflector holes in your mower deck's
discharge opening. If the bracket can not be located
correctly using existing holes, it will be necessary to
drill one or two 5/16" diameter holes in the deck. See
figure 26.
Use existing holes or drill 5/16"
diameter hole or holes.
ADAPTER BRACKET
"\ I
\
\\\\\\
\\
\
DECK ADAPTER
MOWER DECK
Keep edge of adapter as close
as possible to offset in bracket
FIGURE 26
7,
,
With deck adapter positioned correctly over the
discharge opening, use the adapter bracket as a
template and drill three 9/32" diameter holes in the top
of the deck adapter. See figure 28.
Bolt deck adapter to bracket using three 1/4" x 3/4"
bolts, nylon washers, 1/4" flat washers and 1/4" lock
nuts. Nylon washers should be against the inside of
the deck adapter. See figure 28.
DECK ADAPTER
(3) 1/4" NYLOCK
NUTS
_/ ADAPTER
_____._ BRACKET
(3) NYLON / _ MOWER DECK
WASHERS
(3) 1/4" STEEL WASHERS
(3) 1/4" x 3/4" HEX BOLTS
FIGURE 28
15
,
Assemble end of hose and a hose clamp over the
round opening of deck adapter and tighten clamp. GO
DIRECTLY TO THE OPERATION INSTRUCTIONS
ON PAGE 18.