Filter
Top Products
ASSEMBLY OF THE DECK ADAPTER
(#62468) TO THE MOWER DECK
Contents of Hardware Pack for Deck Adapter:
See Figure 28.
Key Qty. Description
A
B
C
D
E
F
G
H
I
d
K
2 Hex Bolts, 5/16" x 1"
3 Hex Bolts, 1/4" x 3/4"
2 Carriage Bolts, 5/16" x 3/4"
3 Hex Lock Nuts, 5/16-18 Thread
3 Hex Lock Nuts, 1/4-20 Thread
3 Fiat Steel Washers, 1/4" Std.
12 Flat Washers, 5/16" Std.
3 Nylon Washers, 21/64
1 Mounting Strap
1 Angle Bracket
1 Mounting Bracket
F
NOT SHOWN FULL SIZE I
j
FIGURE 28- FULL SIZE
NOTE: Not all of the hardware will be used for any one
particular fit up.
• Remove the mower discharge deflector from your
mower deck. Save the deflector and hardware for
remounting.
&
CAUTION: Mower deflector must be
replaced when Mow-N-Vac deck adapter
is removed. Do Not operate mower unless
adapter or deflector is in place and
properly mounted.
Identi_ your mower deck (see fold outs) and cut out
the correct discharge opening template for your
mower deck size. Ifthere is notemplate for your deck
size you can make your own template by marking
around a piece of cardboard held against the edge of
the discharge opening.
Tape the template tothe face of the adapter, locating
template approximately 1/2" from front and 1/4" down
from top of adapter. Keep as close to top as possible.
See figure29. Mark outline of template on face of
adapter usingwhite crayon, nail or scriber. Drill a
starting hole inside the outline, then use a saber saw
or key hole saw to cut out the opening. See figure 29.
1/4" DOWN
IMPORTANT: Keep cut-off as close to
the top edge as possible.
1/2" FROM FRONT
FIGURE 29
IF YOU HAVE A MURRAY TRACTOR WITH A 38" OR
40" DECK, SKIP DIRECTLY TO PAGE 16.
IF YOU HAVE A MURRAY TRACTOR WITH A 46"
DECK, SKIP DIRECTLY TO PAGE 16.
14