Filter
Top Products
Installthepolyhardtopoverthefrontandsidepanels.
Fastenusingfourteen1/4"x3/4"hexbolts,1/4"flat
washers,1/4"lockwashersand1/4"hexnuts.See
figure17.
Assemble the five clamps onto the cart flanges,
placing one in f_ontcenter and two on each side,
positioned approximately 12"from each end. Use a
3/8" x 1-1/2" hex bolt to secure each clamp from the
bottom. See figure 17.
POLY HARD TOP
1/4" HEXNUT 1/4"LOCK
WASHER
CLAMP
CLAMP
FRONT
3/8" x 1-1/2"
FIGURE 17
5/16" HEX NYLON CROSS
LOCKNUT WASHER BRACE
•5/16" x 3/4•
HE)( BOLT
FIGURE 18
BOLT
DOOR
BRACKET
; -HEXNUT
Assemble one short tie strap to each side of rear door
using one 1/4" x 1-1/4" hex bolt, two 1/4" fiat washers,
one 1/4" lock washer and one 1/4" hex nut. Assemble
an "S" hook through the loose end of each strap. See
figure 19.
• Assemble a 1/4" x 1" hex bolt with a 1/4" hex nut to
outside of hole on each side of cart bed and secure
from inside with a 1/4" lock washer and a 1/4" hex
nut. See inset in figure 19.
• Assemble door to rear of cart by resting bottom of
door on door support brackets and rotaUng top of door
forward to meet cross brace. Latch top of door on
each side. See figure 19.
• Hook both the fie straps onto the 1/4" x 1• hex bolts
which were just assembled. See figure 19.
Assemble a door latch at each end of the crossbrace
usinga 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" hex locknut. Place nylon washer between door
latch and crossbrace. Tightenso that latch issnug
butwillstillrotate.See figure 18.
Assemble door support brackets underneaththe rear
ofthe cart bed by removing the hex nutsfrom the
bolts shown in figure 18. Fasten the brackets to the'
cart using the same hex nuts which were removed.
._CROSS BRACE_. DOOR
, _ ,, _f t_" _,
"_,;1/4"'FLJ_T_-_'_? HEX BOLT
LOCK
STRAP ' --'_ "" 1/4
..... T"'_"-'_I/4 • FLAT
1/4 xl
; ,, WASHOR
HEX NUT ""_u-_1/4" LOCK WASHER
FIGURE 19
11