Filter
Top Products
9
FIGURE 11
• Push two ange bearings into each of the drive disk
assemblies. See gure 11.
• Push a ange bearing into each of the seven drive
disks, from the side shown in gure 12.
FIGURE 12
• Press anged bearings into both of the end plates.
See gure 13.
• Place the 1/4" thick spacer onto the spike disk
shaft and then insert the shaft through the anged
bearing in the left hand end plate. See gure 13.
FIGURE 13
SPIKE DISK
LONG SPACER TUBE
• Place a short spacer tube, a drive disk, a 5/8" at
washer, another drive disk and a second 5/8" at
washer onto the shaft. Fit the short spacer tube onto
the anged bearing in the end plate. See gure 14.
FIGURE 14
FIGURE 15
IMPORTANT: When assembling the spike disks, be sure
they face in the direction shown in the instructions.
• Place two spike disks, separated by a long spacer
tube, onto the shaft. Fit the long spacer tube onto the
ends of the anged bearings in the disks. See gure
15.
DRIVE DISKS
5/8" FLAT WASHER
SHORT SPACER
TUBE
FLANGED
BEARING
FLANGED
BEARING
DRIVE DISK
ASSEMBLY
FLANGED
BEARING
SPIKE DISK
FLANGED
BEARING
FLANGED
BEARING
1/4" THICK SPACER
SPIKE DISK SHAFT