Filter
Top Products
11
• Place two 5/8" at washers separated by a long
spacer tube onto the shaft. See gure 20.
FIGURE 20
SPIKE DISK
SHORT SPACER TUBE
• Place a spike disk and a short spacer tube onto the
shaft. Fit the short spacer tube onto the ends of the
anged bearings in the spike disk and in the end
plate. Push the shaft on through the anged bearing
in the end plate. See gure 21.
5/8" FLAT WASHER
LONG SPACER TUBE
FIGURE 21
FIGURE 23
• Place a 5/8" at washer onto the end of the spike disk
shaft and secure the shaft with a 1/8" x 1-1/2" cotter
pin. See gure 22.
• Fasten the two drive disks to the shaft using two 1/8"
x 1-1/2" cotter pins. See gure 22.
5/8" FLAT
WASHER
1/8" x 1-1/2"
COTTER PIN
DRIVE DISKS
FIGURE 22
• Assemble the chain onto the two sprockets on the
left side of the hopper. Fasten the ends of the chain
together using the connecting link. See gure 23.
• Place the chain cover over the chain and fasten it to
the hopper end plate using two self tapping screws.
See gure 23.
CONNECTING
LINK
CHAIN
SELF
TAPPING
SCREW