Filter
Top Products
17
Ho l l i s t o n
™
Adaptor Installation - Continued
Step 12e. Locate the bottom cap and screw as shown
in Figure #5, using the screw that you earlier removed
from the light kit adaptor assembly (see step 11c) and
insert cap screw through the hole in the center of the
cap and attaching the cap the bottom of the fan as
shown in Figure #5 on this page. Then tighten the
screw with the provided screwdriver.
Step 12f. Locate the end cap screw plug shown in
Figure #6, align and insert the two (2) holding tabs
located on the screw plug with the slots located in the
center of the end cap, then press on the plug locking
end cap screw plug into place also as shown in Figure
#6 and Figure #7.
Figure #5
BOTTOM
CAP
CAP SCREW
#8-32
Figure #8
END CAP
SCREW
PLUG
Figure #7
END CAP
SCREW
PLUG
PLUG
TABS
Figure #6
Adaptor Installation END
NOTE: To continue installation instruction,
go to (Inteli-Touch 3 - Control Installation)
within this document.