Filter
Top Products
11
Ho l l i s t o n
™
Step 4e. Slide the hanging adapter cover down over
the motor coupling as shown in Figure #6, making
sure that the adapter cover is covering the motor
coupling as in shown Figure #7.
FAN PREPARATION - CONTINUED
Install Lightbulbs:
Step 5. Insert the six 7-watt lightbulbs for the uplight
as shown in Figure #1.
NOTE: When replacing these lightbulbs, be sure to
use only 7-watt maximum.
(6) 7-watt
Uplight Bulbs
LIGHTBULBS
LIGHTBULB INSTALLATION (uplight)
Figure #6
HANGING
ADAPTER
COVER
MOTOR
COUPLING
HANGING THE FAN
Step 6a. To hang the fan body in the canopy, hold
the fan body rmly and insert the ball into the canopy
opening. Check that no wires are pinched. Rotate the
fan body until the slot in the ball ts into the pin opposite
the canopy opening.
Step 6b. Trim excess motor wires, leaving at least 6
inches above the downrod. Strip
1
/
2
-inch insulation from
the end of each wire using a wire stripper (available at
your local hardware store).
BALL
SLOT
PIN
CANOPY COVER
RING
HANGING
ADAPTER COVER
Figure #7
Figure #1