Filter
Top Products
7
Holliston
™
DC
fan InStallatIon
(not to scale)
After turning the power OFF at its source (either the
circuit breaker or fuse box), lower the old xture and
disconnect the wiring. Check the ceiling xture outlet
box to be sure it is marked “Approved for Ceiling Fan
Mounting.” If it is not, a new box must be installed.
GettInG Started
If you do not have an existing xture located where
you wish to place your Casablanca fan, an approved
ceiling xture outlet box must be installed and wired.
Note: The weight of this fan is 26 pounds.
ceIlInG plate InStallatIon
After removing the old xture, check the outlet
box to ensure that it is supported by a joist or beam
across its upper surface. If not, a 2 x 4 stud must be
installed.
Remove the knockout plug in the center of
the outlet box or drill a
1
/
2
-inch hole for the lag screw
to pass through. Then drill a
1
/
4
-inch guide hole into
the joist or beam to a depth of 3 inches.
Route the outlet box wires through the hole
of the ceiling plate as shown. Attach the ceiling plate
to the outlet box with the screws provided, making sure
the outlet box wires are not being pinched.
JOIST
CEILING
WIRING
CEILING
PLATE
WASHERS
Outlet Box
Hardware
CEILING FAN-
APPROVED
WIRING BOX