Filter
Top Products
23
There are six individual speed settings for the fan. Each speed is
indicated by the number on the controller. To properly calibrate all
speeds of the motor, run the fan on speed "6" for 90 seconds after
each AC power reset.
To select the desired fan speed:
Press the number on the controller corresponding to the speed
desired. is off.
Note: It is normal for the fan to start in the "High" position from "O" before changing to
the selected speed.
Step 1. Locate a 2x4 wall stud in a convenient
location.
Step 1. Orient the control bracket as shown over
the 2x4 stud.
Step 1. Use the provided screws in the mounting
holes. Install and tighten screws by hand only.
The direction of airow can be changed from downward to upward
or from upward to downward.
To reverse the airow:
1. Make sure the fan is on and blades are turning.
2. Press the reverse button. The fan will stop and teeter back
and forth and then change directions.