Filter
Top Products
15
Holliston
™
DC
SwItcH HoUSInG and end cap InStallatIon
(not to scale)
Locate the light kit adaptor assembly and
screw plug as shown in the switch housing hardware
section above. You will need to install the complete
assembly for no light kit installation.
Locate and remove the one #6-32
screw that is attaching the bottom cap to the light
kit adaptor assembly as shown in Figure #2 and
remove the bottom cap. Do not discard screws during
disassembly.
Locate and remove the four #6-32 screws
from the cap and remove the cap. Do not discard the
screws during disassembly.
Figure #3
Figure #4
NOTE: Locate the light kit adaptor as shown in Figure #2,
this adaptor plate will need to be attached to the fan during
fan installation for light kit or no light kit installation.
Figure #1
Figure #2
- Installation:
NOTE: If you are installing your fan without a light
kit attached as shown in Figure #1, continue with these
installation instruction