Filter
Top Products
17
Holliston
™
DC
Locate the bottom cap and screw as shown
in Figure #5, using the screw that you earlier removed
from the light kit adaptor assembly (see step 11c) and
insert cap screw through the hole in the center of the
cap and attaching the cap the bottom of the fan as
shown in Figure #5 on this page. Then tighten the
screw with the provided screwdriver.
Locate the end cap screw plug shown in
Figure #6, align and insert the two (2) holding tabs
located on the screw plug with the slots located in the
center of the end cap, then press on the plug locking
end cap screw plug into place also as shown in Figure
#6 and Figure #7.
Figure #5
Figure #8
Figure #7
Figure #6
NOTE: To continue installation instruction,
go to (Inteli-Touch 3 - Control Installation)
within this document.