Filter
Top Products
22
Step 1. Open battery
compartment door by pressing
down and sliding battery door
down.
Step 2. Install 1 "A23" "MN21"
alkaline battery in the space
provided. Please observe proper
polarity placement.
+
-
Step 1. At the circuit breaker or fusebox, turn the power off
for the fan you want to change.
Step 2. Open the battery compartment door of the remote
control and remove the battery.
Step 3. Change the dip switch settings, assuring that they are
different from the previously installed fan(s).
Step 4. Re-install the battery in the proper polarity.
Step 5. At the circuit breaker or fuse box, turn the power back
on for the fan whose frequency you are changing.
Step 6. Within 60 seconds of restoring power, push and hold
the SET button in the battery compartment for 5 seconds.
(If there is a light on the fan it will ash twice indicating
completion of this step) You should now have control of the fan.
Step 7. Reinstall battery compartment door.
Note: You may want to label your controls
to assure you do not mix them up.
1 2 3 4
ON ECE
ON
D
1 2 3 4
ON ECE
SET
Your fan has the ability to disable the dimming feature to allow the use of CFL bulbs.
To activate CFL mode:
1. Open the battery compartment door.
2. With the fan power off, move the toggle switch towards "D".
3. Replace the battery compartment door.
4. Press the power button again to restore power to the fan.
To cancel CFL mode:
5. Open the battery compartment door.
6. With the fan power off, move the toggle switch towards "ON".
7. Replace the battery compartment door.
1 2 3 4
ON ECE
ON
D
SET
D
ON
Caution: CFL
bulbs will
not function
properly when
dimmed,
which may
result in
ickering or
reduced bulb
life.