Filter
Top Products
21
Holliston
™
DC
Connect the wires of the motor to the
wires of the light xture. Connect the wire from
the motor to the wire of the light xture and
connect the two wires together, as shown in
Figure #15. Secure the connection using the wire
nuts.
Align the two (2) posts on the light kit
assembly and the two (2) holes located on the switch
housing cap as shown in Figure #16 and insert the
posts on the light kit assembly into the two (2) holes
on the light kit adaptor plate cap as shown in Figure
#16.
Locate the two (2) switch housing cap
screws as shown in Figure #17. Then attach the light
xture to the switch housing on the bottom of the fan
as shown in Figure #17 and tighten the screws with
the provided screw driver.
At this time locate and continue the
installation of the light kit by using the installation
instructions that were provided within the box with the
light kit. Once the light kit has been installed return to
the next section (WALL CONTROL PREPARATION)
of this document. You will need to install the wall
control (W-84) and learn how to operate the fan and
light on the Holliston fan.
Figure #15
Figure #17
Figure #16