Filter
Top Products
3
Stealth
®
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and
check them against the parts listed here. Before discarding packaging material, be certain that all parts have
been removed.
STEALTH INSTALLATION INSTRUCTIONS
FAN PREPARATION
PERMA
•
LOCK™ HARDWARE
DOWNROD & BALL
ASSEMBLY
ALLEN SET SCREW
1
⁄
4
-20 x
1
⁄
4
”
(PRE-INSTALLED)
1/8”
ALLEN WRENCH
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma
Lock™ downrod and ball assembly.
Step B. Using the provided allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning, this will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided
allen wrench to ensure safe operation of your fan.
Tip: The downrod has a tapered
thread that is designed to lock com-
pletely when correctly installed.
CAUTION: Failure to fully lock in the downrod
before securely tightening the allen set screw may
cause the fan to separate from the downrod during
normal operation!
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
ALLEN
SET SCREW
DOWNROD
& BALL
ASSEMBLY
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, IN-
STALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND
LOCK THE ASSEMBLY