Cal Spas Portable Spas Hot Tub User Manual


 
Page 20 2009 Portable Spa Owner’s Manual
LTR20091001, Rev. A
Operating Your Spa
Diverter Knobs
Diverter knobs are the
larger knobs located
around the top of your
spa. They allow you
to divert water through
jets from one side of
the spa to the other,
or in most cases from
oor jets to wall jets.
This is accomplished
by rotating the diverter
knob to the left (counterclockwise), decreasing the
amount of water ow through a section of jets. To increase
the amount of water ow through the other section of
jets, rotate the handle to the right (clockwise).
Air Venturis
Air venturis are the smaller
knobs located around
the top of your spa. They
can also be distinguished
from diverter knobs by
the arrows and the words
“OFF”, “ON” and “AIR”
marked on them. Each one
will let you add a mixture
of air with the jet pressure.
This is accomplished by rotating the air venturi knob
to the left (counter-clockwise) to increase the amount
of airow through the jets. To decrease the amount of
airow through the jets, rotate the handle to the right
(clockwise).
Adjustable Therapy System™
Pump On/Off
This button allows the
user to turn on and
off the ATS™ seat
pump. Press this
button once to turn the
pump on. Once on,
the green LED light on
the control panel will
illuminate, indicating
that the system is
operational. To turn off
the pump, press the “PUMP ON/OFF” button a second
time. Note: The pump must be on prior to operating any
other features of this system.
Pulse Mode
This button allows the user to turn the ATS™ massage
control on and off. Press the pulse button once to turn
on the massage control. Once pressed, the orange LED
in position number 1 will light, indicating the number one
pulse mode. Each press of either the up or down button
will move the orange LED up or down to the next pulse
mode.
Note: Allow one second between each button press.
Pressing the button quickly may cause improper
operation. To turn the pulse mode off and return to
normal pump operation, press the “PULSE MODE”
button a second time.
Up
This button allows the user to cycle up from one through
seven massage modes one at a time. Each mode
offers a different pulsating massage. Some modes are
faster than others, so just cycle through them to nd the
massage you like best.
Down
This button allows the user to cycle down through all
seven massage modes, one at a time.
Time Reset Mode
Pulse mode will normally run for 15 minutes then
automatically shut off. For another 15-minute session,
press the “PUMP ON/OFF” button and the “PULSE
MODE” button. A green LED will blink and the pump
will run on high-speed mode as part of a 15-minute cool
down period. After that, the pump will stop automatically
and the green LED light on the panel will continue to
blink for one minute then shut off automatically. After the