Filter
Top Products
2009 Portable Spa Owner’s Manual Page 15
LTR20091001, Rev. A
Operating Your Spa
When rst powered up, the
electronic system will perform
a self-diagnostic check and
then it will automatically heat
to and maintain a temperature
of 37.5˚C until you change the
set temperature as listed in the
“Temperature Adjustment” section
below.
These instructions will describe
features and options that your
particular spa may not be equipped
with.
Initial Start-up
When your spa is rst powered up, it displays some
conguration codes and then goes into priming mode
(Pr will appear on the display panel). This mode lasts up
to four minutes and then the spa begins to heat to its pre
-programmed temperature of 37.5˚C. You can exit the
priming mode early by pressing UP or DOWN buttons.
Temperature Adjustment (26.0˚C - 40.0˚C)
The start-up temperature is set at 37.5˚C. The last
measured temperature is constantly displayed on
the control panel. Note that the last measured spa
temperature is displayed. The displayed temperature
will be updated when the pump has been running for at
least two minutes.
Press the UP or DOWN buttons once to display the set
temperature. Each time either button is pressed again,
the set temperature will increase or decrease depending
on which button is pressed. After three seconds, the
control panel will automatically display the last measured
spa temperature.
Time
When time hasn’t been programmed, the TIME icon
ashes. To set the time, press the TIME button and
then the MODE/PROG button. Use the UP and DOWN
buttons to adjust time. See the next page for more
detailed instructions.
Standard, Economy, Sleep, and Standby
Modes
Mode/Prog: This button is used to switch between
standard, economy, and sleep modes.
Press MODE/PROG to enter mode programming.1.
8005 and 9005 Electronic Control Operation
Press the DOWN button to cycle through to the 2.
desired mode.
Press MODE/PROG to conrm selection.3.
Standard Mode: This is programmed to maintain the
desired temperature. Note that the last measured spa
temperature displayed is current only when the pump
has been running for at least two minutes. The “STAND”
icon will display until the mode is changed.
Economy Mode: Economy mode heats the spa to the
set temperature only during lter cycles. The “ECON”
icon will display until the mode is changed. Pressing the
JETS 1 button while in economy mode puts the spa in
standard-in-economy mode, which operates the same
as standard mode but reverts back to economy mode
automatically after one hour. During this time, pressing
the MODE/PROG button will revert to economy mode
immediately.
Sleep Mode: Sleep mode heats the spa to within 11˚C
of the set temperature only during lter cycles. The
“SLEEP” icon will display until the mode is changed.
Standby Mode: Pressing “Warm” or “Cool” then “Jets 2”
will turn off all spa functions temporarily. This is helpful
when changing a lter. Pressing any button resets the
spa.
Jets 1 and Jets 2
Press the JETS 1 button once to turn pump 1 on or off
and to shift between low and high speeds if equipped.
If left running, the low speed turns off after two hours
and the high speed turns off after 15 minutes. On non-
circulation systems, the low speed of pump 1 runs when
the blower or any other pump is on. It may also activate
for at least two minutes every 30 minutes to detect the
spa temperature and then to heat to the set temperature if
needed, depending upon the mode. When the low speed