Filter
Top Products
Page 12 2009 Portable Spa Owner’s Manual
LTR20091001, Rev. A
Operating Your Spa
Initial Start up
When rst powered up, it will automatically revert
to Priming mode. A Pr on the topside display will
indicate this. Priming mode will be active for less
than ve minutes at which time the heater will
be activated and the water temperature will be
maintained in Standard mode. The spa will heat
to 37.5°C at start up until the set temperature is
changed as described below.
Temperature Adjustment
(Range 26°C to 40°C)
The electronic control panels display the
actual water temperature in degrees Celsius.
The displayed temperature will only be current
after the pump has been running for at least
2 minutes.
To display the temperature that the spa is set
to:
Press the Temp button. The temperature •
setting will ash.
While the display is ashing, each time you press •
Temp button, the set temperature will change up or
down one degree.
If the desired temperature is opposite of the direction •
each press of the button is making, release button,
allow display to stop ashing and then press Temp
button to change temperature the other direction.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start in
standard heating mode.
St will light briey on the main display. In this mode, •
the heating system will automatically maintain the
set spa temperature. In the economy-heating mode,
the heating system will only activate during ltration
times.
Ec will display solid if temperature is not current •
and will alternate with spa temperature if measured
temperature is current.
Economy mode will heat the water to the set •
temperature while Sleep mode, indicated by a SL
on the main display, will also only activate the heater
during the ltering cycles but will only heat the water
to within 10°C of the set temperature. Like Economy
mode, SL will display solid when temperature is not
current and will alternate with actual temperature
when it is current.
NOTE: Displayed temperature will only be current after
the pump has been running for at least two minutes.
Switching Modes
Press Temp button followed by the Light button.•
Press the same sequence to switch to the next •
mode.
Jets
Press the Jets button:
Once to activate low speed pump.•
Twice to activate high speed.•
Three times to return to turn pump off.•
Operating Your Spa
6105 and 6205 Electronic Control Operation