2011 Portable Spa
LTR20111000, Rev. D
Operating Your Spa
www.calspas.com
15
Initial Start up
When rst powered up, your spa will perform a self-
diagnostic check and go into priming mode. When
the control panel displays PR, IMMEDIATELY do the
following:
Press the JETS 1 button to turn on the pump and 1.
let it run for 10 seconds. The pump should be
running in low speed.
Press the JETS 1 buttons again and let the pump 2.
run in high speed for 10 seconds.
Press the JETS 1 button again to turn off the 3.
pump. The pump should be left in the off position
for 10 to 15 seconds.
Repeat steps 1 through 3 until water is owing 4.
through all the jets and all air is removed from the
plumbing.
When the spa has nished priming, the heater will be
activated and the water temperature will be maintained
in standard mode. The spa will heat to 100°F (37.5°C)
at start up until the set temperature is changed as
described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The start-up temperature is set at 100°F (37.5°C). The
last measured temperature is constantly displayed on
the control panel. Note that the last measured spa
temperature is displayed. The displayed temperature
will be updated when the pump has been running for
at least two minutes.
Operation
These instructions will describe features and options that your particular spa may not be equipped with.
Auxiliary controls for the
9800 system
Press the “UP” or “DOWN” buttons once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the control panel will automatically display
the last measured spa temperature.