Filter
Top Products
2010 Portable Spa
LTR20101000, Rev. C
Clear Water Plan
www.calspas.com
31
Cal Zone Quest Ozonator
The Cal Zone ozone generator releases ozone into the spa water. You will still need to test for chlorine and
occasionally replenish it to return the chlorine level to the baseline.
This plan and its chemical dosages are intended for spas equipped with the optional Cal Zone Quest 1000 / 2000
Ozonator or Del Zone Eclipse Ozonator. The chemical references are designed for Cal Spas chemicals only.
Start Up
Follow the spa start up procedures for chlorine Clear Water Plan. 1.
Set the spa’s ltration time for “F-4”. This activates the ozonator and produces the ozone gas.2.
Note: Filtration time may need to be increased with heavy bather load.
Day One (Monday)
Test spa water using chlorine test strips. (You will need to use a small amount of chlorine as a supplemental 1.
sanitizer)
Based on the test strip readings:2.
Adjust total alkalinity (acceptable range of 80-120 ppm).•
Adjust the pH if needed (range is between 7.2 to 7.8).•
Add 1 tablespoon of chlorine granules.•
The recommended level of Chlorine is 1-3 ppm.•
Add 2 oz of “Stain and Scale Defense”.3.
Remove dirty lter from the spa and rinse off.4.
Place your extra clean lter cartridge back into the spa.5.
Vacuum debris from the bottom of your spa with the spa vacuum.6.
Day Two (Friday)
Test spa water using chlorine test strips.1.
Based on the test strip reading: 2.
Adjust total alkalinity, then the pH if needed. •
Add 1 tablespoon of chlorine granules (if needed).•
Add 2 oz of Cal Spas “Oxidizer Shock” to spa. 3.
Run spa for 15 minutes with cover off.
Replace cover.4.
Cal Clarity Bromine
Generator
The Cal Clarity bromine generator automatically
generates and releases free bromine into the spa
water. You will still need to test for bromide and
occasionally replenish it to return the bromine level
to the baseline.