2010 Portable Spa
LTR20101000, Rev. C
Operating Your Spa
www.calspas.com
14
Initial Start up
When rst powered up, your spa will perform a self-
diagnostic check and go into priming mode. The
topside will display PR to indicate this. Priming mode
will be active for less than ve minutes.
Sometimes the pump fails to prime, especially when
spa owners do not ll their spas through the lter
canister. You can avoid priming problems by following
these steps during priming mode.
Press the JETS 1 button to turn on the pump and 1.
let it run for 10 seconds. The pump should be
running in low speed.
Press the JETS 1 buttons again and let the pump 2.
run in high speed for 10 seconds.
Press the JETS 1 button again to turn off the 3.
pump. The pump should be left in the off position
for 10 to 15 seconds.
Repeat steps 1 through 3 until water is owing 4.
through all the jets and all air is removed from the
plumbing.
When the spa has nished priming, the heater will be
activated and the water temperature will be maintained
in standard mode. The spa will heat to 100°F (37.5°C)
at start up until the set temperature is changed as
described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The start-up temperature is set at 100°F (37.5°C). The
last measured temperature is constantly displayed on
the control panel. Note that the last measured spa
temperature is displayed. The displayed temperature
will be updated when the pump has been running for
at least two minutes.
Press the “UP” or “DOWN” buttons once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the control panel will automatically display
the last measured spa temperature.
Time
When time hasn’t been programmed, the “TIME” icon
ashes. To set the time, press the “TIME” button and
then the “MODE/PROG” button. Use the “UP” and
“DOWN” buttons to adjust time. See the next page
for more detailed instructions.
Standard, Economy, Sleep, and Standby
Modes
Mode/Prog: This button is used to switch between
standard, economy, and sleep modes.
Press “MODE/PROG” to enter mode 1.
programming.
9800 Electronic Control Operation
These instructions will describe features and options that your particular spa may not be equipped with.