Filter
Top Products
Savannah Rectangle Gazebo Assembly
2007 Woodcrest Series Gazebo Owner’s Manual Page 7
LTR20071040, Rev. A
Step 1: Wall Panel Assembly
The assembly instructions contained in this manual are for the Savannah Rectangle Gazebo that measures
12’x16’. The assembly instructions will be the same for the 8’x12’, 10’x10’, 10’x12’, 10’x16’ and 12’x12’ models.
The only difference in the assembly of these fi ve models is the amount of steps the owner must perform. Follow
the written steps in conjunction with the fi gures that are shown.
All wall panels are pre-assembled at the factory before being shipped. The smooth side of each wall panel should
be facing the inside of the gazebo. Check the parts list that came with your gazebo and make sure that all the
parts are present.
Stand two panels up side by side. Attach the panels together using 5 drywall screws (Figure A).
At each wall seam, attach a 2”x4” Splice. This will tie-in and stabilize the walls (Figure A).
Repeat this step until all the panels are attached. Figure B will show you the proper arrangement of panels.
The rounded corners attach to the
wall panels the same way, with fi ve
2 1/2” screws. The owner must use
care when securing the wall panel
and rounded corner together, as any
damage incurred during assembly is
not covered by the warranty.
1.
2.
3.