Filter
Top Products
Page 4 2007 Woodcrest Series Gazebo Owner’s Manual
LTR20071040, Rev. A
Savannah Octagon Gazebo Assembly
Step 1: Wall Panel Assembly
The assembly instructions contained in this manual
are for the Savannah Octagon Gazebo that
measures 18’x18’. The assembly instructions will
be the same for the 10’x10’, 12’x12’ and 14’x14’
models. The only difference in the assembly of these
three models is the amount of steps the owner must
perform. Follow the written steps in conjunction with
the fi gures that are shown.
All wall panels are pre-assembled at the factory
before being shipped. The smooth side of each wall
panel should be facing the inside of the gazebo.
Check the parts list that came with your gazebo and
make sure that all the parts are present.
Stand panels up vertically with the fl ush side of
the panel facing inward (fi t panels together as
shown in Figure A.
Drill holes in all 2”x4” boards. The holes have
already been drilled for the wall panels. Line
up the holes and mark the 2”x4” and drill
accordingly.
Insert the provided drywall screws into the pre-
drilled holes and tighten with a phillips-head
screwdriver (Figure B).
Repeat this step until wall panel assembly is
complete (Figure C).
Using drywall screws to attach the corbels, as
shown in Figure C.
1.
2.
3.
4.
5.