Filter
Top Products
16
Removal
Snow Blade Removal
1. Lower the snow blade to the ground.
2. Remove the four (4) hair pins (C, Figure 16) from the
control arm (A) and remove the control arm from the
snow blade assembly.
3. Remove the control arm from the tractor.
NOTE: The control arm support bracket can be left on the
tractor.
4. Remove the bell crank hair pin (A, Figure 17) and
remove the snow blade lift arm (B) from the bell crank
(C).
5. Remove lift arm (B) from the mower deck lift arm by
removing the hairpin cotter pin (D) from the stand off
(F). Fully remove the snow blade lift arm (B) from the
tractor.
NOTE: Leave the stand off attached to the mower deck
lift arm.
C
A
B
Figure 16. Control Arm Removal
A. Control Arm
B. Ball Joints
C. Hair pins
F
E
B
B
D
A
B
C
Figure 17. Control Arm Removal
A. Hair pin
B. Snow Blade Lift Rod
C. Bell Crank
D. Hair pin
E. Flat Washer
F. Standoff
CAUTION
Make sure to shut off the engine and lock the
tractor brakes or block the rear wheels before
beginning the snow blade removal process.