Filter
Top Products
10
Briggs & Stratton Power Products Home Generator
Installation Manual
50/60 Hz Switch
12 Volt DC,
.5 Amp Output
Exercise Failure
Remote LED Output
Emergency Failure
12 Volt DC, .5 Amp Output — Internal power supply.
50/60 Hz Switch — Allows factory to select between
either 50 Hz or 60 Hz. Make sure the switch is in the
60 Hz position at all times for proper generator operation.
Emergency Failure — Use NO2, Common2 and NC2 to
hook up a siren, light, etc. to alert you in case of a failure
during a power outage.
Exercise Failure — Use NO1, Common1 and NC1 to
hook up a siren, light, etc. to alert you in case of a failure
during the exercise cycle.
Remote LED Output — Use this to hook up the extra
remote LED supplied with the generator.The remote LED
will turn on and off in a series of blinks if certain faults are
detected in the generator.
KNOW YOUR SYSTEM CONTROL BOARD
Compare this Control Board illustration with your generator to familiarize yourself with the location of these important
controls and connections: