Filter
Top Products
GB - 33
Add Fuel Stabilizer
1. Turn the fuel valve off while engine is
running and allow the engine to run until
it stops. Turn engine OFF when it begins
surging to avoid engine damage.
2. Add fuel stabilizer, following the
manufacturer’s instructions.
3. Turn fuel valve on after adding fuel
stabilizer.
4. Re-start engine.
5. Run the engine outdoors for 1 minutes to
be sure that treated gasoline has
replaced the untreated gasoline in the
carburetor.
6. Slow the engine to an idle speed.
7. Repeat step 1 above.
SERVICE PARTS
Order the following parts through your
Dealer:
Part No. Description
00036800 Ariens Hi-Temp Grease
(3, 3 oz. cartridges)
21534100 Spark Plug (920014)
21547400 Spark Plug (920013)
07200513 Impeller Belt
07200603 Traction Belt
53200500 Shear Bolts
00170800 Friction Disc
00592900 Gas Stabilizer (4 oz.)
00432600 Headlight Bulb, 20 Watt
06400920 Gear Case Filler Plug Seal
Washer
ACCESSORIES
See your authorized Ariens dealer to add the
additional accessories available to your
Sno-Thro model.
Part No. Description
72406900 Slicer Bar Kit
72406500 Front Weight Kit
72600300 Composite Skid Shoe Kit
73203600 Sno-Thro Cover
82000100 28" Brush Attachment
72408000 Snow Cab
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Engine will
not
crank/start.
1. Fuel tank is empty.
2. Fuel shut-off valve
closed.
3. Build up of dirt and
residue around
governor/carburetor.
4. Key Switch not in run
position.
5. Electric starter not
functioning.
1. Fill fuel tank (see FILLING
FUEL TANK on page 19).
2. Open fuel shut-off valve.
3. Clean area around
governor/carburetor.
4. Put Key Switch into run
position.
5. Check for a bad starter or
connections.