Filter
Top Products
GB - 26
MANUAL DISCHARGE CHUTE
DEFLECTOR (920013)
(Figure 24)
Deflector must stay in selected position while
throwing snow.
To adjust, loosen then retighten the wing
knob to desired tension.
REMOTE DISCHARGE
DEFLECTOR CONTROL
ADJUSTMENT (920014)
(Figure 25 and 26)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control
(Figure 25).
.
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on remote
deflector cable attached to the chute
deflector (Figure 26).
3. To adjust the deflector lower:
Loosen bottom adjustment nut and
tighten top adjustment nut.
To adjust deflector higher:
Loosen top adjustment nut and tighten
bottom adjustment nut.
4. Check the deflectors range of travel and
repeat adjustment as necessary.
DISCHARGE CHUTE
(Figure 27)
If discharge chute does not stay in position
while operating, tighten nut on carriage bolt at
pivot point to increase tension on spring.
Figure 24
OS8215
1. Wing Knob
2. Discharge Chute Deflector
3. Discharge Chute
1
2
3
Figure 25
OS8066
Adjustment Nut
Figure 26
2
1
1. Adjusting Nuts
2. Cable Support Bracket
3. Remote Deflector Control Cable
3
OS8217
Figure 27
OS8220
1. Spring
2. Nut
1
2