Filter
Top Products
GB - 10
Unfold Upper Handlebar Assembly
(Figure 7 and 8)
1. Rotate the handlebar into operating
position.
NOTE: Be careful not to damage cable spring
hooks when rotating handlebar upward.
.
2. Install the remaining handlebar
hardware attaching the upper handlebar
assembly to the lower handlebar
(Figure 5).
3. Tighten all hardware.
4. Remove packaging around shift rod.
5. Rotate shift rod into place and tighten
hardware.
6. Connect shift rod to speed selector arm
and adjust as specified in Speed
Selector Adjustment on page 27.
7. Remove slack from attachment and
traction cables using the following steps
(Figure 8):
a. Loosen jam nut on cable
adjustment barrel
b. Turn the adjustment barrel down
to shorten cable and remove all
cable slack.
c. Retighten jam nut.
Connect Headlight Wire Harness
(Figure 9)
NOTE: The headlight wire harness comes
attached to the upper handlebar assembly.
1. Route the wire harness along the interior
of the right side of the handlebars.
2. Connect to the engine electrical plug.
Figure 7
1
2
3
1. Shift Rod
2. Handlebar Hardware
3. Shift Rod Hardware
4. Upper Handlebar Assembly
5. Lower Handlebar
4
5
Figure 8
1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
2
3
1
OS8255
Figure 9
2
4
3
1. Wire Harness
2. Cable Tie
3. Cable Anchor
4. Engine Electrical Plug
1
2