Filter
Top Products
OPERATION
Versa 03/09 Operation Section 3-11
© 2009 Alamo Group Inc.
OPERATION
5.CONNECTING ATTACHING HEADS TO THE BOOM
With a forklift or hoist, lower the Boom Weldment
down on the A-Boom Head. Align the Boom
Weldment with the A-Boom Head Hitch Post. Insert
special bolts 1" x 9" (item 1) and (item 2), 3/4" x 5-1/2"
into Boom Weldment and Hitch Post. Attach nuts 1"
(item 3) and (item 4), 3/4" to bolt and tighten securely.
Note: Additional support may be needed at the end
of the Boom to aid in installation.
OPS-B-0004_B
5.1 Connecting Mower Head Hydraulics
Attach the 1-1/4" Hoses, with the spiral steel band,
from the Articulating Arm (Refer to Figure) to the
hydraulic motor on the A-Boom Head. (Refer to
Figure). Use recommended hose end torque
values in chart below. OPS-B- 0019_B