Filter
Top Products
ASSEMBLY
VERSA 03/09 Assembly Section 3-10
© 2009 Alamo Group Inc.
ASSEMBLY
CENTER MOWER ASSEMBLY
Install idler arm assembly to bearing plate. Do not
secure at this time. ASM-FL-0052.
1. Remove fasteners and shaft protector from end
of drive shaft. Lightly grease shaft. Install key
and drive shaft pulley. Do not secure at this time.
ASM-FL-0052.
2. Align all three pulleys. Use spacers and shims
provided to achieve alignment, then secure idler
arm assembly with cotter pin. Secure drive shaft
pulley with fasteners removed in Step 1, above.
3. Install drive belt. ASM-FL-0053_A.
4. Attach spring. One end is inserted in idler arm
spring arm hole; the other end is attached to the
long outboard bearing plate bolt.