Filter
Top Products
OPERATION
MAVERICK 3/09 Operation Section 3-29
© 2009 Alamo Group Inc.
OPERATION
• Select F-1 to power the motor. This is best done when the engine RPM is at idle. Doing this at a high RPM
will cause the system pressure to surge sending fluid over relief and causing excess heat to be introduced
into the system.
• At any time the cutter-head motor E-stop can be pushed to disable the motor circuit. If this is done the
switch must be raised in the RUN position before the motor circuit can be reactivated.
• At this time the motor circuit is powered and the mower head is active.
• This screen also shows the tank temperature in degrees Fahrenheit.
• To turn off the motor, Key F-1.
• Joystick is now disabled
The Joystick Master Control Switch must be OFF to prevent accidental movement of the
boom and cutting head whenever the mower is not being operated.
.
Operate the Tractor and/or Implement controls only while properly seated in the Tractor seat
with the seat belt securely fastened around you. Inadvertent movement of the Tractor or
Implement may cause serious injury or death.
(SG-29)