Filter
Top Products
OPERATION
MAVERICK 3/09 Operation Section 3-25
© 2009 Alamo Group Inc.
OPERATION
The XP2, is a controller module that is mounted at
the front of the tractor next to the Maverick control
valve. The function of this component is to provide
a gateway for incoming and outgoing information.
Information is sent via the network to this module in
order to provide control of the solenoids for valve
operation. REFERENCE PRODUCT MANUAL
FOR XP2 CAN MODULE. AVAILABLE ON THE
INTERNET AT www.iqan.com VIEWABLE WITH
ABOBE ACROBAT READER, AVAILABLE AT
www.adobe.com.
The XT2, is also a controller module that is
mounted at the front of the tractor on the side of the
tank. The function of this component is to provide a
gateway for incoming and outgoing information.
This module receives input from the
instrumentation, then provides that information to
the network for further utilization. REFERENCE
PRODUCT MANUAL FOR XT2 CAN MODULE.
AVAILABLE ON THE INTERNET AT www.iqan.com
VIEWABLE WITH ABOBE ACROBAT READER,
AVAILABLE AT www.adobe.com.
The XS is an expansion module that provides extra
input and output capabilities in order to gain more
flexibility on the network. The XS is responsible for
receiving the signals from the joystick and other in-
cab inputs and making them available on the
network. REFERENCE PRODUCT MANUAL FOR
XS EXPANSION MODULE. AVAILABLE ON THE
INTERNET AT www.iqan.com VIEWABLE WITH
ABOBE ACROBAT READER, AVAILABLE AT
www.adobe.com.
The rotating parts of this machine continue to rotate even after the Tractor has been turned
off. The operator should remain in his seat for 60 seconds after the brake has been set, the
PTO disengaged, the tractor turned off, and all evidence of rotation has ceased.
(SBM-5)
“Wait a minute...Save a life!”