Filter
Top Products
OPERATION
FACLON 15/10 03/09 Operation Section 4-33
© 2009 Alamo Group Inc.
OPERATION
The unit is designed to greatly reduce the
clipping and debris build up on the cooler.
However the cooler will periodically need to be
inspected and cleaned to remove material,
usually once or twice a day depending on
mowing conditions. Use a short brush to brush
the clippings off the cooler fins on the underside.
Brush the clippings out from under the tank
where the air enters the cooler. Remove any
debris or clippings from the top of the fan as
needed. If the cooler becomes excessively
clogged, the oil temperature could become too
high.
During sharp turns be careful not to allow the tire
to come in contact with the tongue or other parts
of the mower. When you get to the end of a pass,
slightly raise the mower (2-4”) before turning.
Never raise the mower entirely while the blades
are turning. If the mower must be raised higher
than 12” from ground level, disengage the tractor
PTO and wait for all mower rotation to come to a
complete stop before proceeding to raise the
mower. NEVER raise the mower wings while the
blades are turning. OPS-R-0027F
Do not let the Blades turn when the Mower Deck is raised for any
reason, including clearance or for turning. Raising the Mower deck
exposes the Cutting Blades which creates a potentially serious hazard
and could cause serious injury or even death from objects thrown from
the Blades.
(SRM-07)