Filter
Top Products
MAINTENANCE
A84B 03/07 Maintenance Section 5-4
© 2007 Alamo Group Inc.
MAINTENANCE
DRIVELINE LUBRICATION
Grease Fittings are located on the Cross Assembly of each U-Joint and on the telescoping tubes. Grease the
U-Joint after each 8 hours of use. FIGURE Mnt-0024. Do not force grease through the Needle Cup
Assemblies. Grease the telescoping tubes after every 8 hours use. Some PTO-to-Hitch connections may
necessitate cutting a hole in the shields to be able to align the Grease Fitting holes for lubrication. Lubricate
the shield bearings every 16 hours. FIGURE Mnt-0024.
Make certain that the Driveline Integral Shields are free to telescope and rotate around the
Driveline without binding.