Filter
Top Products
6
Secure the relay pack near the battery of the ATV or 5.
other location on the ATV out of harms way.
Thread the 3 wire lead from the relay pack forward 6.
through the ATV frame on the same side as the handle
bar switch. Avoid threading wire close to moving parts,
hot parts or pinch points. Use 1 or 2 nylon ties to hold
wire in place.
Connect the three leads from the handlebar switch into 7.
the three leads from the relay pack matching up the
red, green and black wires. See Figure 4.
Thread the bullet connector from the relay pack forward 8.
through the frame and out through the front of the ATV.
Avoid threading wire close to moving parts, hot parts
or pinch points. Use 1 or 2 nylon ties to hold wire in
place.
Plug the bullet connector from the relay pack into the 9.
bullet connector on the actuator.
Attach the red wire from the fuse to the positive terminal 10.
on the ATV battery. Attach the negative lead (black
wire) from the relay pack to the negative terminal on
the ATV battery.
Use the handlebar switch to fully extend the actuator, 11.
then disconnect the actuator.
2x4
AWD
PRE-ASSEMBLED
SCREW
PRE-ASSEMBLED
NUT
Attach the tethered safety switch to the handlebar using 12.
(4) pre-assembled screws and (4) pre-assembled nuts.
See gure 5.
Thread the wiring through the ATV and out the front of 13.
the ATV. Avoid threading wire close to moving parts,
hot parts or pinch points. Nylon ties can be used to
hold wire in place.
FIGURE 4
FIGURE 5
BATTERY
+
POSITIVE
"HOT" POST
BLACK
RED
FUSE
HANDLEBAR
SWITCH
BULLET
CONNECTOR
RELAY PACK
ACTUATOR
3-WIRE
LEAD