Filter
Top Products
Function Commands
Command
:FUNCtion{1 | 2}:ADD <source>[,<source>]
Defines a function that takes the algebraic sum of two defined operands.
<source>
{CHANnel<number> | FUNCtion<number> |
RESPonse<number> | WMEMory<number> |
<float_value>}
<number>
For channels: an integer, 1 through 4, indicating the slot in which the channel
resides, followed by an optional A or B identifying which of two possible
channels in the slot is being referenced. For functions: 1. For waveform
memories (WMEMory): 1, 2, 3, or 4. For TDR responses: 1, 2, 3, or 4.
<float_value>
A real number.
Command
:FUNCtion{1 | 2}:BWLimit {{CHANnel<number> |
FUNCtion<number> | RESPonse<number> |
WMEMory<number>}, <bandwidth>}
Provides a bandwidth limit filter function. You can use this function on
waveforms to limit the bandwidth of the signal. In TDR or TDT applications
where the accuracy of normalization is not required, you can use this to
simulate a bandlimited signal through a device under test.
<number>
For channels: an integer, 1 through 4, indicating the slot in which the channel
resides, followed by an optional A or B identifying which of two possible
channels in the slot is being referenced. For functions: 1 or 2. For waveform
memories (WMEMory): 1, 2, 3, or 4. For TDR responses: 1, 2, 3, or 4.
<bandwidth>
Real number indicating frequency limit for the specified function.
13