Filter
Top Products
6-9
Utilities
To set up the I/O port to use a controller
To set up the I/O port to use a controller
Use the I/O menu to make settings if you have a controller connected to the
oscilloscope.
1Press the Controller softkey to set the controller interface to RS-232 or
GPIB.
GPIB will be a selection on this softkey only if you have the optional N2757A
GPIB Interface Module connected to the oscilloscope.
The RS-232 configuration to the connector on the rear panel is:
Data bits - 8
Stop bits - 1
Parity - none
2Press the XON DTR softkey to set the RS-232 handshake.
The RS-232 handshake protocol can be set to:
XON XON (transmit on)/XOFF (transmit off), a software handshake, or
DTR data terminal ready, a hardware handshake.
The default handshake is DTR.
3Press the Baud softkey to set the RS-232 baud rate.
The RS-232 baud rate can be set to 9600, 19200, 38400, or 57600.
The default baud rate is 9600.
4 If you have the optional N2757A GPIB Interface Module connected to
the oscilloscope, turn the Entry knob to set the GPIB address shown in
the
Address softkey.
The Address softkey is only displayed if the GPIB module is attached to the
oscilloscope.
Turn the Entry knob to set the GPIB address of this oscilloscope. The
oscilloscope address can be set to any address from 0 to 30. The default
oscilloscope address is 7.
Controller
type
RS-232
Baud rate
Return to
previous menu
Handshake GPIB
address