3
Wireless transmitter module
• Switch the TV off with the power switch.
• Attach the wireless module to the back of the TV as shown.
• Connect the attached cable to the wireless module connector.
• Switch the TV on.
Surround loudspeakers
• There are two NXT SurfaceSound
®
* surround loudspeakers
which have to be connected to the wireless receiver box 2
R and L.
If one of the connection cables is too short the 4 m extension
cable supplied can be used.Table stands as well as wall
supports are supplied.
• The Surround sound loudspeakers can be located behind or
to either side of the listener.The front of the loudspeakers do
not have to face the listener.The distance between the TV and
the surround speakers should not exceed 15 m.
Wireless receiver box
Connect the
13V DC adaptor supplied to the 13V DC IN 1
input at the bottom of the receiver box. Connect the adaptor
to the mains.
The slide channel switch 3 has been set default to channel 1
in the factory.
The indicator on the receiver box shows that the speakers
are in standby. During sound transmission the indicator turns
to green. 10-15 min. after the sound transmission of the TV
has stopped, the indicator turns back to red to indicate the
low power standby.
The system has already been configured in the factory to
work properly. In rare circumstances, interference from
external RF (wireless) equipments such as RF headphones,
mobile phones or remote controls for lights, may occur.Then
it may be necessary to shift to another wireless channel.
Important:Always be sure that the Wireless receiver box
and the Wireless Surround settings (see p. 9) are switched to
the same transmitting channel.
In rare cases, when no RF surround sound is possible, or
when there is too much interference, use the wired back up
solution. See Wired rear loudspeakers, p. 28.
FM Wire Antenna connection
Connect the supplied FM wire antenna to the
FM RADIO
ANTENNA 75 ø connector at the back of the TV.Adjust the
position of the FM antenna for the best reception.
Note: for better FM stereo reception, connect an outdoor FM
antenna or cable antenna to the
FM RADIO ANTENNA 75 ø
connector using a 75 ø coaxial wire.
Wireless Surround speaker system
WIRELESS MODULE
®
®
AUDIO in
(TV)
2.
8V RMS
AUDIO in
(TV)
2.8V RMS
13V DC in
13V DC in
LR
4 /15W
LR
4 /15W
1 22
1
2 3
44
32
1
2
33
44
75
ANTENNA
FM RADIO
75
ANTENNA
FM RADIO
* NXT
®
is a trademark of New Transducers Limited
2214.2 gb 18-09-2003 14:07 Pagina 3
