11
Set/Change code
The Child lock feature (see TV, Features, p. 15)
allows you to lock channels to prevent others
from watching certain programmes.To watch
locked channels, a 4-digit code must be
entered.The Set/Change code menu item
allows you to create or change a Personal
Identification Number (PIN).
& Select Set/Change code.
é If no code exists yet, the menu item is set to
Set code. If a code has previously been entered,
the menu item is set to
Change code.Follow
the instructions on screen.
Important:You have forgotten your code !
& Select Change code in the General menu and
press
OK.
é Press the cursor right and enter the overriding
code 8-8-8-8.
“ Press the cursor again and enter a new
personal 4-digit code.The previous code is
erased and the new code is stored.
This menu allows you to indicate the peripheral
you connected to one of the external inputs.
& Press the cursor right to enter the list of types
of peripherals attached to the selected input.
é Select the peripheral device with the cursor
up/down.
Once you have selected the source type, e.g.
DVD, this source will automatically be selected
when your remote control is in DVD mode,
see p. 4, and when you press the v key on
the remote control.
Centre input - Centre in volume
When you have connected a surround receiver
to the TV, the loudspeakers of the TV can act as
centre speaker, making a separate centre
speaker unnecessary.
Select
Centre input On or Cinema Link.
Select
On in case you have connected an
external audio receiver without Cinema Link.
Select
Cinema Link in case you have
connected a Cinema Link surround receiver.
When having selected
On you can adjust the
Centre in volume with the cursor left/right to
correct volume level differences of the external
audio receiver and speakers.
Digital audio in 1 or 2
& Select Dig audio in 1 or 2.
é Select one of the corresponding connections in
the list when you connected your digital device
together with the additional audio cable you
connected to one of the digital audio in sockets
of your TV. See Connect Peripheral equipment,
Digital equipment, p. 27.
Source
EXT1
EXT2
EXT3
EXT4
SIDE
Centre input
Centre In vol.
Dig. audio in 1
Dig. audio in 2
Setup
If a decoder or a descrambler is connected, see
p. 27, you can define one or more programme
numbers as decoder programme numbers.
& Select Decoder with the cursor right.
é Select Programme.
“ Select the programme number under which
you have stored the programme coming from
your decoder.
‘ Select Status.
• Select the input used to connect your decoder:
None, EXT1 or EXT2.
• Select
None if you do not want the selected
programme number being activated as a
decoder programme number.
Note: Select
EXT2 when the decoder is connected
to your EasyLink video recorder.
Decoder
Decoder
Programme
Status
Setup
Source
2214.2 gb 18-09-2003 14:07 Pagina 11
