29
Connect audio receiver
Although your TV is already equipped with a Digital MultiChannel decoder you might want to connect
your own MultiChannel surround receiver.
MultiChannel surround receiver with or without digital input connectors
& Connect a MultiChannel surround receiver to the AUDIO OUT
R and L connectors at the back of your TV.
é If you want the loudspeakers of your TV to act as centre
speaker, also connect an audiocable to the MultiChannel
surround receiver
CENTRE OUT connector and to the
CENTRE IN connector at the back of your TV.
“ Select Centre input On in the Source menu; See p. 11.The
loudspeakers of the TV will now only produce centre sound.
‘ If necessary, adjust the volume level of the centre sound in the
Centre in volume menu item of the Source menu.The overall
volume has to be controlled via the MultiChannel surround
receiver.
( In case of a Digital MultiChannel surround receiver, also connect
the receiver to the
DIGITAL AUDIO OUT connector.
In this case the loudspeakers of your TV can not act as centre
speaker. Select
Centre input Off in the Source menu, see p. 11.Also
see the instructions manual of your Digital MultiChannel surround
receiver.
See the separate supplied Cinema Link instruction manual
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Press the v key on the remote control repeatedly to select EXT1, EXT2, EXT3, EXT4 or SIDE
according to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
To select connected equipment
Cinema Link Surround receiver
Recorder or DVD with EasyLink
The recorder (VCR or DVD+ RW) or DVD can be
operated with the remote control via the Recorder
or DVD menu on screen.
& Press the MENU key on the remote control.
é Select the Recorder or DVD menu with the
cursor up/down.
“ Press the cursor left/right, up/down to select
one of the recorder or DVD functions.
The key ® for recording can be operated in the TV
mode.
If your EasyLink recorder has the system standby
function, when you press the B key for 3 seconds,
both TV and the recorder are switched to standby.
Òp‡π † ® Ï
Rwd Play Stop Play Ffw Rec Eject
Recorder
Òp ‡ π † Ï
Prev. Play Stop Play Next Eject
DVD
CENTRE INCENTRE INCENTRE IN
AUDIO
OUT
DIGITAL
AUDIO
OUT
CENTRE IN
CENTRE IN
AUDIO
OUT
2214.2 gb 18-09-2003 14:07 Pagina 29
