2. MACHINING PARAMETERS
2.2 Control Parameters
II - 9
2.2 Control Parameters
# Item Contents Setup range (unit)
8101 MACRO SINGLE Select the control of the blocks where the user
macro command continues.
0: Do not stop while macro block continues.
1: Stop every block during signal block
operation.
0/1
8102 COLL. ALM OFF Select the interference (bite) control to the
workpiece from the tool diameter during tool radius
compensation and nose R compensation.
0: An alarm is output and operation stops when
an interference is judged.
1: Changes the path to avoid interference.
0/1
8103 COLL. CHK OFF Select the interference (bite) control to the
workpiece from the tool diameter during tool radius
compensation and nose R compensation.
0: Performs interference check.
1: Does not perform interference check.
0/1
8105 EDIT LOCK B Select the edit lock for program Nos. 8000 to 9999.
0: Program can be edited.
1: Editing of above program is prohibited.
0/1
8106 G46 NO REV-ERR
(For L system only)
Select the control for the compensation direction
reversal in G46 (nose R compensation).
0: An alarm is output and operation stops when
the compensation direction is reversed (G41
→ G42‚ G42 → G41).
1: An alarm does not occur when the
compensation direction is reversed‚ and the
current compensation direction is maintained.
0/1
8107 R COMPENSATION Not used.
8108 R COMP Select Not used.
