1. LIST OF ALARMS
1.1 Operation Alarm
I - 8
Error No. Details Remedy
1036
Synchronous control designation disable
The synchronous control operation
method selection (R435 register) was
set when the mode was not the C axis
mode.
The synchronous control operation
method selection (R435 register) was
set in the zero point not set state.
Mirror image disable state
The external mirror image or parameter
mirror image was commanded during
facing turret mirror image.
• Set the R435 register to 0.
• Check the program and parameters.
1037
Synchronous control was started or
canceled when synchronous control could
not be started or canceled.
• Check the program and parameters.
1038
A movement command was issued to a
synchronous axis in synchronous control.
• Check the program.
1106
Spindle synchronous phase calculation
illegal
The spindle synchronization phase
alignment command was issued while
the spindle synchronization phase
calculation request signal was ON.
• Check the program.
• Check the sequence program.
(The bold characters are the messages displayed on the screen.)
M90 PARAM SET MODE
M90 Messages output when the setup parameter lock function
is enabled are displayed.
Error No. Details Remedy
—
Setup parameter lock released
The setup parameter lock is released.
Automatic start is disabled when setup
parameters can be set.
• Refer to the manual issued by the
machine manufacturer.
